![]() ![]() They also are not a true and perfect diameter. All water pipe, conduit, fencing, etc., have different properties. Quite often the cut charge is more than the piece you may have needed. I found out that it is a heck of a lot more expensive when you only buy in small quantities. Be safe!!!!! I miscalculated a few times and had to go back for more tube. Good welds are vital to safety! Measure twice - cut once. Have all worked checked by a professional. I have seen a few minor spills that could have been much worse because the bike was ridden without brakes. Do not allow any pre-test runs before the brakes have been added. I drilled the holes first, then using clamps, positioned them in the right position before tack welding. I used a make-shift wooden jig to hold the frame while I measured to ensure the axel bolt was in the right position. Make sure the rear tire is also aligned straight. Make sure the engine and clutch are aligned straight with the rear sprocket. I wanted to be sure the position of the handlebars foot pegs and seat fit my nephew. I tack-welded the frame only until I had the complete mini bike built. I used the details I have provided to make these parts. ![]() I started by building the frame, bending the necessary tubes to create the main frame and the handlebars.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |